Description
It is necessary to enter the diagnosis case after installation.
It is necessary to replace the RT3 radio and screen. The female connector of the interface is connected to the original connector, and the male connector is connected to the new GPS car radio. Finally, connect the power supply to the remote screen. All of this does not require any electrical modifications to your vehicle, and it can be restored to its original configuration.
Q & A
Reviews (0)
Related products
Cable and Connector
#28 Car DSP Amplifier Wiring Harness for Chevrolet Cruze 2015~2018 Chevy Regal
Cable and Connector
Wiring Harness for Mitsubishi 2006+ (Rockford) Aftermarket Chinese Radio Power Cord
Cable and Connector
Wiring Harness for Mitsubishi Pajero IV 2006+ Aftermarket Stereo
Cable and Connector
For Peugeot Citroen DS NAC Radio Adapter Connector Extension Cable
Cable and Connector
Car DSP Amplifier Cable for Universal VW Opel ISO Wiring Harness
Cable and Connector
Car Radio Power Cable for Mitsubishi 2007+(without amplifier) Aftermarket Chinese Radio
Cable and Connector
Power Cord for Mitsubishi 2007+ (Rockford) Aftermarket Chinese Radio
Cable and Connector
MRN RCC SMEG+ SMEG Conversion Wiring Harness Adapter For Peugeot 2008 208 7″ Screen
Reviews
There are no reviews yet